Select Page
The 536,870,912 byte (512×2 20 ) capacity of t...
Image via Wikipedia

Repairing PC issues might look too complicated to unravel yourself, but many end up being reasonably straightforward. You will still pay a lot to have someone fix most major issues for you, so why don’t you try and see if you can do it yourself first?

There are plenty of relatively easy fixes. On a scale of one to ten, replacing RAM is generally about a 2, installing a new hard drive is 6 or seven, but still do-able. Replacing a graphics card or sound card is no more than a 5 or 6.

A word to the sensible: Static electricity can spoil the circuitry inside your computer. Before you reach inside the computer, ground yourself with a grounding strap; or at the very least touch the frame of the computer first. If you don’t want to attempt the repair yourself or are not successful then check out PC repair Apple Valley Mn on the internet for assistance!

Below are some Problems that you can potentially repair on your own:

  1. You turn on the computer and nothing happens.The lights dont come on, it doesnt beep, just nothing at all occurs no lights, no beeps, no fan noise. What is the very first thing you do? Be sure the darn thing is plugged in. Even if you are fully certain that it is connected, double check.

Presuming that it is plugged in, you most likely have a bad power supply. This is a metal box located in the top and back of the computer. It is generally held in by 4 screws and the power cable connects to it. A wiring harness exits the power supply within the computer. Numerous power connectors are attached to the ends of the wires. These plug into drives, fans and presumably other gizmos. The harness also will have wires to the motherboard. It doesn’t matter which wire connects where, as long as the connector fits.

When you open the computer, this mess of wiring can be exceedingly frightening. Study it, and you will find it less puzzling. Note the links in writing, when necessary. Disconnect the wires and take away the power supply. Take it to the computer store and get a replacement with the same wattage. Figure on spending $50-$70 for the part. If you don’t want to attempt the repair yourself or are not successful then check out virus removal Shakopee Mn on the internet for assistance!

  1. If you regularly gives the “Blue Screen of Death“. You may have a RAM problem. Do not trouble writing down the message on the blue screen or searching the Microsoft Help and Support data base, its a big waste of your time. Instead here is the simple way to figure out if its bad RAM.

Shut off and open up the computer and locate the RAM sticks. If there is multiple, take out all but the 1st stick of RAM. Now plug in the computer and turn it on, does it turn on? Now turn it off, take out the one stick of RAM and replace it with another. Turn it on again and see if it is working. Repeat this process with each stick of RAM one at a time. If one stick is bad, the computer likely wont start up when that stick is installed on it’s own.

Assuming you have a RAM problem, they are simple to fix. You could attempt swapping out memory sticks from a working computer, but that memory must be the same kind to work. If that doesn’t work, take the old memory to a computer store, they may be ready to test it, or you may test it in a mates computer yourself.

The sticks of RAM go in the sockets close to the CPU, they are about 4 inches long. Take away the suspect memory and figure out what kind you want. Memory prices are all over the place, depending on type and speed; ensure you get the correct type for your PC. When you install the new memory into the slot, put one side in, then press down on the other. You may likely have to use light force to press it down, and the locks on each end will pop into place when the RAM stick is seated properly. If you don’t want to attempt the repair yourself or are not successful then check out PC repair Lakeville Mn on the internet for assistance!

Enhanced by Zemanta